• Official FOX GRIP Damper Rebuild Guide
• MTB-Hydraulics GRIP Seal Kit (ships in letter mail!)
• MTB-Hydraulics Air Spring Seal Kit (ships in letter mail!)

• 2-in-1 GRIP Clamp Kit:
  • 10mm Shaft Clamp (GRIP damper shaft + air shaft)
  • GRIP Damper Body Clamp
• Dust Wiper Seal Press Tool
• Basic Damper + Air Shaft Driver
• Float NA/NA2 Plastic Bullet Tool (works with all 10mm Fox air shafts)

• Use Fox 4wt fluid in damper and on damper-side lowers
• Use Fox 20wt Gold or Motorex Supergliss on the air shaft and air-side lowers
• Use Slickoleum / SRAM Butter on all seals, o-rings, dust wipers, bushings, etc.

References

• Essential Tools for Fork Service
• How to Clamp Small Shafts
• How to Clamp Large Shafts
• MTB Suspension Jargon

Pro Tips

• Fully open rebound and compression before bleeding, or it won’t work
• Only disassemble the GRIP compression/mid-valve if they leak, they last forever otherwise
  
• Never insert the damper shaft fully after the bleed is done, always leave 2–3 cm from the top or you will lose oil
• Grease the Dust Wiper Seals and lower leg bushings with SRAM Butter

• Do not use an adjustable wrench, always use a 26–28mm chamferless socket for the top cap
• Clean shafts with alcohol before clamping
  
• Do not open the GRIP compression assembly unless it’s leaking

Disclaimer: This is a DIY home toolkit. No guarantee of compatibility with taper-cast forks. Always read fork markings and verify damper + air shaft type before opening. See Terms of Service.