SHOCKWAVE Grip Ends are designed for riders who naturally ride close to the edge of the handlebars and prefer an aggressive elbows-out riding position.

Unlike traditional bar ends that force a straight wrist position or fully trap the hand inside the bar width, SHOCKWAVE Grip Ends support the outer palm while still allowing a natural diagonal hand angle.

The asymmetric orientable design allows the support position to be adjusted depending on riding style, wrist angle, and hand placement.

This allows riders to maintain a more relaxed grip on the handlebars while still feeling stable and supported in rough terrain, compressions, and high-speed riding.

The textured surface lightly grips onto gloves and grip rubber to improve stability without creating a locked-in feeling.

SHOCKWAVE Grip Ends are designed around aggressive MTB riding posture rather than traditional bar ends.

Many riders naturally angle their hands and keep their elbows outward while descending. Traditional circular or flat bar ends can interfere with this position and force the wrists into an unnatural straight alignment.

SHOCKWAVE Grip Ends maintain support at the edge of the bars while still allowing part of the outer palm and pinky area to naturally overhang the outside of the handlebar.

This reduces the need to tightly squeeze the grips and can significantly reduce hand and arm fatigue during long or rough runs.

The result is a more natural riding feel with increased confidence, control, and freedom of movement.

Two versions are available:

• SHOCKWAVE Grip Ends — Support → compact support shape with textured surface
• SHOCKWAVE Grip Ends — Freedom → extended support shape for additional palm support and hand angle freedom

Compatible with most MTB grips between approximately 32 mm and 36 mm outer diameter.

Compatible with most standard and lock-on grips once modified for installation.

Each set includes a dedicated left and right side.

Currently available only in black.

The installation system is designed to remain simple and requires only basic tools.

• Drill a centered 6 mm hole through the end of the grip
• Insert the supplied M6 bolt through the SHOCKWAVE Grip End
• Install the internal expanding nut inside the handlebar
• Use the supplied adapter with a standard 8 mm Allen key
• Orient the Grip End to your preferred angle
• Tighten lightly to approximately 3 Nm
• Go ride

Unlike some systems, no long ratchet extensions or difficult internal installation tools are required.

A complete installation video guide will also be available.

Important installation notes

• Do not overtighten the hardware
• Recommended tightening torque is approximately 3 Nm
• Always verify proper installation before riding
• Left and right Grip Ends are side-specific and clearly marked
• Grip Ends are not interchangeable due to their asymmetric design
• Grip rubber flexibility may slightly affect feel and support
• Compatibility with oversized grips has not been fully tested yet
• Crash-tested successfully during aggressive MTB riding conditions

Traditional MTB bar ends often prioritize full hand containment or perfectly straight wrist positioning.

SHOCKWAVE Grip Ends were designed around how aggressive riders actually position their hands during descending and rough terrain riding.

The goal was to create a support system that improves confidence and reduces fatigue without restricting natural hand movement or aggressive riding posture.

Simple, supportive, confidence-inspiring, and designed to feel natural once installed.

Proper installation is required before riding.

The rider is responsible for verifying compatibility and ensuring safe installation on their specific handlebars and grips.

Depending on grip shape and bar setup, fitment and feel may vary.

By purchasing or using this product, you agree to our Terms of Service.